We developed a custom solution for the OCD-DPC1B-1213-SB90-H72 model for users who need Profibus communication in a standard industrial housing with straightforward field installation. This configuration uses a 58 mm synchro flange, a 10 mm solid shaft with single-side flat, and 13-bit singleturn plus 12-bit multiturn absolute feedback. Unlike heavy hazardous-area versions, its strength lies in practical bus integration: 3 x M12 connectors, address selection, and terminal resistor switching simplify on-site commissioning. Typical production lead time: 15 working days. The original configuration combines optical sensing, binary code, IP65 protection, and a 10–30 VDC supply range.
Technical Key Parameters
- Profibus DP interface
- 13-bit singleturn + 12-bit multiturn resolution
- Binary code
- 58 mm synchro flange
- 10 mm solid shaft, single-side flat, 20 mm length
- 3 x M12 connector layout
- Address selector and terminal resistor switch
- 10–30 VDC supply
- IP65 protection
- Max speed 12000 rpm
Custom Solution Photos
Wiring and Installation Notes
The key integration value of this model is its fieldbus usability in the cabinet and at the machine side. The 3 x M12 arrangement separates supply and bus connections in a way that supports fast replacement and easier troubleshooting. During installation, the solid shaft should be coupled without excessive radial load, especially because the unit is designed for relatively high rotational speed. The built-in address selection and terminal resistor switching should be set before startup so that network topology remains clean and predictable. In retrofit work, this type of configuration is often preferred where technicians want Profibus functionality without using loose flying leads or separate junction assemblies.
Custom Compatible Encoder Solution
- Custom Profibus replacement solution with matching M12 connector architecture
- Mechanical adaptation for 58 mm synchro flange and 10 mm solid shaft layout
- Bus addressing and termination-oriented integration support
- Signal and installation customization for direct replacement of field-installed units
Lead Time and Custom Development
Typical production lead time is 15 working days. We can support custom work for shaft geometry, connector arrangement, and Profibus integration details based on the existing machine interface.
Key Technical Data
| Item | Data |
|---|---|
| Interface | Profibus |
| Resolution | 13-bit singleturn / 12-bit multiturn |
| Code | Binary |
| Supply voltage | 10–30 VDC |
| Mounting | Synchro flange, 58 mm |
| Shaft type | Solid shaft, single-side flat |
| Shaft diameter | 10 mm |
| Connector layout | 3 x M12 |
| Protection class | IP65 |
| Max speed | 12000 rpm |
