For PVS78E-011KRR0BI-0012, EncoderWorks can provide a custom compatible replacement focused on PROFIBUS DP node matching, 12-bit singleturn scaling, KR radial terminal wiring, and stainless-steel clamping-flange mechanics. This model should not be treated as a multiturn encoder or as an SSI feedback unit. The replacement boundary is whether the PLC recognizes the same PROFIBUS device and reads the same singleturn angle after address, termination, and parameter setup.
The PVS78E-011KRR0BI-0012 is an explosion-proof PROFIBUS DP singleturn absolute rotary encoder configuration with binary position data, 12-bit singleturn resolution, 10–30 VDC supply, stainless-steel housing execution, Ø10 mm x 20 mm solid shaft, clamping flange, KR terminal compartment, radial exit, and IP66 flameproof construction. The controller should continue reading 4096 steps per revolution.
The first failure boundary is PROFIBUS configuration. The node address must be unique on the bus, and the terminating resistor must match the encoder’s real position in the segment. If the address switch, GSD setup, Class 2 scaling, preset value, or direction parameter is different, communication may exist while the angle value is still wrong.
This replacement fails when PROFIBUS DP communication is present, but the PLC reads the wrong singleturn angle because node address, bus termination, binary scaling, preset value, GSD setup, or 12-bit parameterization does not match the original encoder.
The second boundary is INOX terminal and shaft installation. Bus-in / bus-out A/B wiring, supply, potential earth, shield continuity, cable-gland sealing, Ø10 mm shaft fit, coupling alignment, and radial terminal clearance must be checked together. Terminal access must not compromise flameproof sealing or shaft alignment.
The replacement decision should first confirm PROFIBUS DP profile compatibility, node address, termination status, 12-bit singleturn scaling, KR radial terminal assignment, 10–30 VDC supply, preset and direction settings, stainless-steel housing execution, Ø10 mm solid-shaft fit, clamping-flange mounting, shield grounding, flameproof terminal handling, and shaft-load limits. EncoderWorks treats PVS78E-011KRR0BI-0012 as an industrial encoder custom compatible solution where PROFIBUS parameter accuracy and INOX terminal mechanics decide field reliability.
Typical production lead time: 15 working days.
Key Data
| Item | Data |
|---|---|
| Model | PVS78E-011KRR0BI-0012 |
| Encoder type | Explosion-proof singleturn absolute rotary encoder |
| Interface | PROFIBUS DP / RS-485 |
| Resolution | 12-bit singleturn |
| Position range | 4096 steps per revolution |
| Supply voltage | 10–30 VDC |
| Shaft size | Ø10 mm x 20 mm |
| Flange | Clamping flange |
| Connection | KR terminal compartment |
| Exit position | Radial |
| Protection focus | ATEX / IECEx flameproof enclosure, IP66 |
| Main failure boundary | Wrong node address, scaling, termination, or terminal handling |
Related Models
PVS78E-011DRR0BI-0013 Stainless PROFIBUS Encoder
PVS78E-022K2R0BN-0013 PROFIBUS Servo Cable Encoder
PVS78E-011DRR0BI-0012 PROFIBUS INOX Encoder
PVS78E-011K2R0BN-0013 PROFIBUS Cable Encoder Solution
PVS78E-021DRR0BN-0016 PROFIBUS Absolute Encoder
