For PVS78E-011DRR0BI-0013, EncoderWorks can provide a custom compatible replacement focused on PROFIBUS DP node matching, 13-bit singleturn scaling, DR radial terminal wiring, and stainless-steel clamping-flange mechanics. This model should not be treated like the 12-bit version or an aluminum-housing encoder. The replacement boundary is whether the PLC recognizes the same bus node and calculates the same 8192-step singleturn angle after parameter setup.
The PVS78E-011DRR0BI-0013 is an explosion-proof PROFIBUS DP singleturn absolute rotary encoder configuration with binary position data, 13-bit singleturn resolution, 10–30 VDC supply, stainless-steel housing execution, Ø10 mm x 20 mm solid shaft, clamping flange, DR terminal compartment, radial exit, and IP66 flameproof construction. The controller should continue reading 8192 steps per revolution.
The first failure boundary is PROFIBUS parameter accuracy. The node address must be unique on the segment, and the terminating resistor must match the encoder’s actual bus position. If the GSD setup, Class 2 scaling, preset value, direction setting, or 13-bit resolution parameter is different, the PLC may communicate normally while the reported angle is wrong.
This replacement fails when PROFIBUS DP communication is present, but the PLC reads the wrong singleturn angle because node address, bus termination, binary scaling, preset value, GSD setup, or 13-bit parameterization does not match the original encoder.
The second boundary is INOX DR terminal installation. Bus-in / bus-out A/B wiring, supply, potential earth, shield continuity, dual cable-gland routing, Ø10 mm shaft fit, coupling alignment, and radial terminal clearance must be checked together. Terminal access must not compromise flameproof sealing or shaft alignment.
The replacement decision should first confirm PROFIBUS DP profile compatibility, node address, termination status, 13-bit singleturn scaling, DR radial terminal assignment, 10–30 VDC supply, preset and direction settings, stainless-steel housing execution, Ø10 mm solid-shaft fit, clamping-flange mounting, shield grounding, flameproof terminal handling, and shaft-load limits. EncoderWorks treats PVS78E-011DRR0BI-0013 as an industrial encoder custom compatible solution where PROFIBUS parameter accuracy and INOX terminal handling decide field reliability.
Typical production lead time: 15 working days.
Key Data
| Item | Data |
|---|---|
| Model | PVS78E-011DRR0BI-0013 |
| Encoder type | Explosion-proof singleturn absolute rotary encoder |
| Interface | PROFIBUS DP / RS-485 |
| Resolution | 13-bit singleturn |
| Position range | 8192 steps per revolution |
| Supply voltage | 10–30 VDC |
| Shaft size | Ø10 mm x 20 mm |
| Flange | Clamping flange |
| Connection | DR terminal compartment |
| Exit position | Radial |
| Protection focus | ATEX / IECEx flameproof enclosure, IP66 |
| Main failure boundary | Wrong node address, scaling, termination, or terminal handling |
Related Models
PVS78E-022K2R0BN-0013 PROFIBUS Servo Cable Encoder
PVS78E-011DRR0BI-0012 Stainless Absolute Encoder
PVS78E-021K5A0BN-0013 Axial Cable PROFIBUS Encoder
PVS78E-011KRR0BN-0013 PROFIBUS Absolute Encoder Solution
PVS78E-011DRA0BI-0013 Axial PROFIBUS Encoder
