A custom compatible replacement for 14-14361-3600 can be supplied by EncoderWorks with the main check placed on 10–30 V push-pull receiver matching, 3600 PPR counter margin, and ATEX keyed-shaft alignment. This model should not be handled like a 1000 or 1800 PPR version. At 3600 PPR, operating speed, cable length, input filtering, and quadrature evaluation can quickly reduce the usable signal margin.
The 14-14361-3600 is an ATEX incremental rotary encoder configuration with photoelectric sampling, 3600 PPR, 10–30 V push-pull output, A/B/0 plus inverted signal channels, IP66 protection, Ø12 mm keyed shaft, clamping flange, and 9-core 2 m cable connection. The 100 kHz output-frequency limit must be checked against real machine speed.
The first failure boundary is edge-frequency margin. A slow-speed test may show correct A/B/0 behavior, while production speed causes missed counts because the controller input cannot preserve every edge. Push-pull output does not remove the need to confirm receiver thresholds, shielding, and input filter delay.
This replacement fails when A/B/0 signals are visible, but the controller loses counts because 3600 PPR, shaft speed, push-pull input behavior, or input filtering exceeds the real 100 kHz signal margin. That is a signal-chain failure, not simply an encoder failure.
The second boundary is push-pull channel mapping. A, B, 0 and inverted A, B, 0 must be wired by signal function. A wrong inverted channel can weaken noise rejection, disturb direction validation, or make zero-pulse homing unreliable.
Mechanically, the Ø12 mm keyed shaft and clamping flange must be checked with the coupling, pulley, or measuring wheel. ATEX suitability, PE shielding, cable routing, axial load, and radial load remain part of the replacement decision.
The replacement decision should first confirm ATEX marking, Ø12 mm keyed shaft fit, clamping-flange centering, 3600 PPR counter capacity, 10–30 V push-pull receiver compatibility, A/B/0 plus inverted channel mapping, 100 kHz output-frequency margin, shield grounding, cable route, operating speed, and shaft load. EncoderWorks treats 14-14361-3600 as an industrial encoder custom compatible solution where push-pull edge margin and keyed-shaft mechanics decide field reliability.
Typical production lead time: 15 working days.
Key Data
| Item | Data |
|---|---|
| Model | 14-14361-3600 |
| Encoder type | ATEX incremental rotary encoder |
| Detection type | Photoelectric sampling |
| Pulse count | 3600 PPR |
| Output switching | 10–30 V push-pull |
| Signal output | A, B, 0 and inverted A, B, 0 |
| Supply voltage | 10–30 VDC |
| Output frequency | Max. 100 kHz |
| Shaft / flange | Ø12 mm keyed shaft, clamping flange |
| Connection | 9-core cable, 2 m |
| Protection class | IP66 |
| Main engineering anchor | Push-pull margin and ATEX shaft |
| Main failure boundary | Edge loss, receiver mismatch, inverted-channel error, shaft overload |
