The replacement of PVS78E-011K2R0BN-0013 should begin with PROFIBUS DP node address, GSD setup, bus termination, 13-bit singleturn scaling, and K2 radial cable verification, and EncoderWorks can provide the required custom compatible encoder solution. It fails as a replacement when the controller can detect the PROFIBUS node but the binary angle value, preset behavior, direction setting, or cable assignment does not match the original encoder.
The PVS78E-011K2R0BN-0013 is an explosion-proof PROFIBUS DP singleturn absolute rotary encoder configuration with binary position data, 13-bit singleturn resolution, 10–30 VDC supply, aluminum housing execution, Ø10 mm x 20 mm solid shaft, clamping flange, K2 2 m radial cable connection, and IP66 flameproof construction. The controller should continue reading 8192 steps per revolution.
The first failure boundary is PROFIBUS bus setup. The node address must be unique, and the terminating resistor must match the encoder’s actual network position. If GSD setup, Class 2 scaling, preset value, direction parameter, or 13-bit resolution setting is changed, communication may remain active while the PLC reports the wrong shaft angle.
This replacement fails when PROFIBUS DP communication is present, but the PLC reads the wrong singleturn angle because node address, bus termination, binary scaling, preset value, GSD setup, or 13-bit parameterization does not match the original encoder.
The second boundary is radial cable and clamping-flange installation. Bus A/B wiring, supply, potential earth, shield continuity, cable strain relief, Ø10 mm shaft fit, coupling alignment, and radial cable clearance must be checked together. Cable pull must not disturb shaft alignment or flameproof cable handling.
The replacement decision should first confirm PROFIBUS DP profile compatibility, node address, termination status, 13-bit singleturn scaling, K2 2 m radial cable assignment, 10–30 VDC supply, preset and direction settings, Ø10 mm solid-shaft fit, clamping-flange mounting, shield grounding, flameproof cable handling, and shaft-load limits. EncoderWorks treats PVS78E-011K2R0BN-0013 as an industrial encoder custom compatible solution where PROFIBUS parameter accuracy and K2 radial cable installation decide field reliability.
Typical production lead time: 15 working days.
Key Data
| Item | Data |
|---|---|
| Model | PVS78E-011K2R0BN-0013 |
| Encoder type | Explosion-proof singleturn absolute rotary encoder |
| Interface | PROFIBUS DP / RS-485 |
| Resolution | 13-bit singleturn |
| Position range | 8192 steps per revolution |
| Supply voltage | 10–30 VDC |
| Shaft size | Ø10 mm x 20 mm |
| Flange | Clamping flange |
| Connection | K2 cable, 7-wire, 2 m |
| Exit position | Radial |
| Protection focus | ATEX / IECEx flameproof enclosure, IP66 |
| Main failure boundary | Wrong node address, scaling, termination, or cable assignment |
Related Models
PVS78E-011DRA0BI-0013 Axial PROFIBUS Encoder
PVS78E-011K2R0BN-0013 PROFIBUS Cable Encoder Solution
PVS78E-011KRR0BN-0013 PROFIBUS Absolute Encoder
PVS78E-021DRR0BN-0016 Absolute PROFIBUS Encoder
PVS78E-011DRR0BN-0013 PROFIBUS Absolute Encoder
