8.A141.6832.3113 Profibus Encoder with Encoder-Side AX Clamp

For 8.A141.6832.3113, EncoderWorks can provide a custom compatible replacement solution for large-shaft Profibus absolute encoder systems where the key checks are ø16 mm H7 bore fit, encoder-side locking-ring clamping, 100 mm torque-arm preload, Profibus node addressing, and GSD-based scaling. This model should not be treated like the torque-arm-side clamp version, because the locking ring position, torque-arm length, and bore size all change the mechanical replacement boundary. Typical production lead time: 15 working days.

This configuration combines a Kübler AX hollow-shaft adapter with a Sendix 5868 absolute multiturn encoder. The AX section provides the ø16 mm hollow-shaft bore, locking ring on the encoder side, and 100 mm torque arm, while the encoder body provides Profibus-DP V0 Class 2 absolute position feedback through three radial M12 connectors. Replacement work should focus on shaft fit, encoder-side clamp access, clamping torque, torque-arm alignment, Profibus node address, GSD configuration, scaling parameters, preset behavior, and shield grounding.

System Limits

The first system limit is AX mechanical installation. The ø16 mm shaft must match the H7 adapter bore without forcing the clamp, and the locking ring must clamp from the encoder side. With a 100 mm torque arm, bracket stiffness and preload must be checked to avoid housing movement, bearing load, or repeatability drift.

The second limit is Profibus commissioning. The PLC must preserve the correct node address, GSD file, encoder profile behavior, scaling, preset value, counting direction, and diagnostic response. If the encoder appears online but the stored profile or scaling is different, the bus may look healthy while the axis reads the wrong mechanical position.

The third limit is the AX operating envelope. The adapter is rated IP64 and has temperature-dependent speed limits. High shaft speed, high ambient temperature, or bracket stress can become the practical failure boundary before the Profibus interface itself becomes unstable.

Wiring & Installation

Before replacement, record the Profibus node address, GSD file, scaling parameters, preset value, counting direction, diagnostic behavior, and any set-button function used by the machine. Also record the three radial M12 connector assignments for Profibus bus wiring, supply voltage, ground, and shield connection.

During installation, confirm the ø16 mm H7 shaft fit, keep the locking ring on the encoder side, and align the 100 mm torque arm without preload. Route Profibus and power cables away from inverter output wiring, maintain shield continuity through the M12 connectors, and avoid ground loops between the encoder housing, machine frame, and cabinet earth. After startup, verify bus status, actual position value, direction, preset response, diagnostics, torque-arm movement, and repeatability over several machine cycles.

Custom Compatible Solution

EncoderWorks can configure the replacement around the installed shaft and Profibus control system:

• Match the AX ø16 mm hollow-shaft adapter, encoder-side locking ring, 100 mm torque arm, and mounting envelope
• Preserve Sendix 5868 Profibus-DP V0 Class 2 feedback, GSD setup, scaling, preset, direction, and diagnostic response
• Adapt the three radial M12 connector layout, 10–30 VDC supply range, bus wiring, and shield grounding
• Review clamp torque, shaft fit, torque-arm preload, IP64 installation limits, and temperature-speed operating margin

Key Data