OCD-PPA1G-0812-SB90-CRW Parallel Multi-Turn Encoder, 10 mm Shaft

We developed a custom solution for model OCD-PPA1G-0812-SB90-CRW. Selected when multi-turn absolute feedback is required via parallel push-pull output, using a 58 mm synchro flange and 10 mm shaft, without migrating to a fieldbus system. Typical production lead time: 15 working days.

Key Specifications

• 12-bit + 8-bit resolution for multi-turn absolute position tracking
• Parallel push-pull output for direct controller integration
• Mechanical multi-turn design without battery maintenance
• 10–30 VDC supply for industrial control systems
• IP65 protection with up to 12000 rpm operation
• 58 mm synchro flange with 10 mm solid shaft

Decision Snapshot

• Best for: parallel absolute retrofit systems
• Key fit: 10 mm shaft, 58 mm synchro flange
• Avoid if: system uses fieldbus communication

Custom Solution Photos

Encoder structure reference: 58 mm synchro flange, 10 mm solid shaft, radial cable outlet.

Signal & Output Logic

• Bit 1–20 parallel output (single-turn + multi-turn combined)
• Includes Latch and DIR control
• Direction configurable via wiring

Selected when: controller requires direct parallel absolute position input
Not suitable for: fieldbus-based systems or incremental-only feedback

Wiring & Installation

• 1 m radial cable
• Verify bit order, latch timing, DIR logic, and common GND before startup
• The most common integration issue is incorrect controller-side signal mapping
• Maintain shaft alignment and confirm cable routing clearance in compact installations

Integration & Compatibility

• Designed for parallel absolute encoder systems
• Matches 58 mm synchro flange and 10 mm shaft installations
• Suitable for multi-turn position feedback without control system modification
• Not intended for Profibus, CANopen, EtherCAT, or similar bus-based systems

Lead Time

Typical production lead time: 15 working days. Customization is available based on shaft fit, cable configuration, and signal requirements.

Key Technical Data