For 14-14361-200, EncoderWorks can provide a custom compatible replacement focused on 10–30 V push-pull receiver matching, 200 PPR controller scaling, and ATEX keyed-shaft alignment. This model should not be treated as interchangeable with 180, 250, or 256 PPR versions. The pulse frequency is low, but exact scaling, reference-pulse logic, and channel wiring still decide whether the machine reads motion correctly.
The first failure boundary is pulse interpretation. If the PLC, drive, or counter expects 180, 250, 300, or another pulse count, the encoder can produce clean A/B signals while speed, length, or angular feedback becomes wrong. Quadrature mode and 0-channel reference use must also match the original setup.
The 14-14361-200 is an ATEX incremental rotary encoder configuration with photoelectric sampling, 200 PPR, 10–30 V push-pull output, A/B/0 plus inverted signal channels, IP66 protection, Ø12 mm keyed shaft, clamping flange, and 9-core 2 m cable connection. At 200 PPR, the main replacement risk is controller setup rather than the 100 kHz output-frequency limit.
This replacement fails when A/B/0 signals are stable, but the controller calculates the wrong motion value because 200 PPR scaling, push-pull input threshold, quadrature evaluation, or reference-pulse logic does not match the previous encoder. That is a configuration and signal-chain failure, not a sensing failure.
The second boundary is push-pull channel mapping. A, B, 0 and inverted A, B, 0 must be wired by function. A wrong inverted channel can weaken noise rejection, direction validation, or homing reliability even when basic counting appears normal.
Mechanically, the Ø12 mm keyed shaft and clamping flange must be checked with the coupling, pulley, or measuring wheel. ATEX suitability, PE shielding, cable routing, and axial/radial shaft-load limits remain part of the replacement decision.
The replacement decision should first confirm ATEX marking, Ø12 mm keyed shaft fit, clamping-flange centering, 200 PPR scaling, 10–30 V push-pull receiver compatibility, A/B/0 plus inverted channel mapping, 100 kHz output-frequency margin, shield grounding, cable route, and shaft load. EncoderWorks treats 14-14361-200 as an industrial encoder custom compatible solution where push-pull signal matching and exact 200 PPR scaling decide field reliability.
Typical production lead time: 15 working days.
Key Data
| Item | Data |
|---|---|
| Model | 14-14361-200 |
| Encoder type | ATEX incremental rotary encoder |
| Detection type | Photoelectric sampling |
| Pulse count | 200 PPR |
| Output switching | 10–30 V push-pull |
| Signal output | A, B, 0 and inverted A, B, 0 |
| Supply voltage | 10–30 VDC |
| Output frequency | Max. 100 kHz |
| Shaft / flange | Ø12 mm keyed shaft, clamping flange |
| Connection | 9-core cable, 2 m |
| Protection class | IP66 |
| Main engineering anchor | Push-pull scaling and keyed shaft |
| Main failure boundary | Wrong scaling, receiver mismatch, inverted-channel error, shaft overload |
