This replacement solution for the CRF65-4096G4096C13 is developed to fully replicate the original encoder’s 4096×4096 multi-turn resolution and parallel output interface. All mechanical and electrical details—including shaft size, flange structure, housing geometry, mounting depth, and connector orientation—are precisely matched, ensuring true plug-and-play installation without any system changes. It is intended for users facing sourcing difficulties or seeking a stable, long-term alternative while maintaining original absolute positioning performance. Typical production lead time is 10–15 working days.
The replacement solution has been applied across markets such as the Middle East, Southeast Asia, Brazil, Russia, and Ukraine. Customers highlight its reliable multi-turn feedback, solid mechanical construction, and stable operation in continuous industrial use. It is well suited for CNC equipment, automated production lines, wind energy systems, and material-handling machinery where consistent and accurate absolute position feedback is critical.
Technical data
| Parameter | Value |
| Electrical data (Valid for all versions unless otherwise stated) | |
| Sensor system | GaAlAs diode, photo-transistor array, precision comparator |
| Parallel output circuits | A = Open collector, C = Darlington, D = Push pull |
| Serial outputs | Differential output to RS422 |
| SS/ ASA | Differential (opto-coupler) for data driver RS 422 |
| Parity bit | Check bit (not to RS - 22 Bit) |
| Error bit output | Data Bit (parallel and SS/ 32 Bit only) |
| Enable circuit for bus operation | Active or inactive |
| Multifunctional inputs (MFP) | Signal input 6 |
| Memory circuit (latch) | Through MFP |
| Code sense | CW or CCW |
| Supply voltage range | 11 to 26 VDC |
| Supply current | 80 mA typ. / 120 mA max. |
| Data rate | 1 to 3 kHz, depending on programming (parallel interface only) |
| Measurement position deviation | ≤ ± 238' (for 4096 pos. / 360°) |
| Disc coding | Gray code |
| Setting cycles EEPROM | ≤ 10^6 |
| Mechanical data | |
| Operating speed | 3000 rpm max. (continuous), 4000 rpm max. (short period) |
| Operating torque | 5 Ncm min. (at 1000 rpm) |
| Wind-up torque | ≤ 10 Ncm (4 Ncm - CRF 66) |
| Angular acceleration | 10^6 rad/s^2 max. |
| Inertial mass of rotor | 50 gcm^2 |
| Permissible axial and radial shift load | 250 N max. |
| Bearing life expectancy | 10^6 turns |
