OCD-PPA1G-0016-C10S-CAW Parallel Single-Turn Encoder, 10 mm Solid Shaft

We developed a custom solution for model OCD-PPA1G-0016-C10S-CAW. Selected when high-resolution single-turn absolute feedback is required via parallel push-pull output, using a 58 mm clamping flange and 10 mm solid shaft, without introducing fieldbus communication. Typical production lead time: 15 working days. The referenced configuration is a single-turn absolute version with optical sensing, 16-bit resolution, Gray code, and direct parallel push-pull output.

Key Specifications

• Interface: parallel push-pull
• Resolution: 16-bit single-turn
• Code: Gray
• Supply: 10–30 VDC
• Protection: IP66/IP67
• Structure: 58 mm clamping flange, 10 mm solid shaft, 20 mm shaft length
• Cable: 1 m axial PVC
• Speed: up to 3000 rpm

Decision Snapshot

• Best for: high-resolution single-turn parallel absolute positioning systems
• Key fit: 10 mm solid shaft, 58 mm clamping flange, 1 m axial cable
• Avoid if: the application requires multi-turn retention or bus communication; that is an engineering fit judgment based on the listed single-turn parallel output structure.

Custom Solution Photos

Encoder structure reference: 58 mm clamping flange, 10 mm solid shaft, axial 1 m cable outlet.

Signal & Output Logic

• Bit 1–16 parallel output
• Includes Latch and DIR control
• Direction configurable via cable or connector setting

Primary integration reason: direct controller-side reading of high-resolution single-turn absolute position. Primary limitation: this structure is efficient for parallel control systems, but not suitable for multi-turn applications or networked motion-bus architectures. That conclusion follows from the published 16-bit single-turn output map and push-pull interface.

Wiring & Installation

• Connection: 1 m axial PVC cable
• Cable: AWG 26, 9.3 mm diameter
• Minimum bend radius: 150 mm

Primary commissioning risk: controller-side signal mapping errors on bit order, Latch, and DIR logic. Primary installation constraint: axial cable routing space. The 10 mm shaft should be aligned carefully because the published bearing life varies with axial and radial load.

Integration & Compatibility

• Designed for single-turn parallel absolute encoder systems
• Matches 58 mm clamping flange installations with 10 mm solid shaft
• Suitable for direct high-resolution position reading without bus conversion
• Not suitable for multi-turn systems or bus architectures; this is a selection conclusion based on the listed interface and output type.

Lead Time

Typical production lead time: 15 working days. Custom adaptation can be developed around shaft fit, cable length, output assignment, and installation requirements.

Key Technical Data