14-14361-1024 Push-Pull Scaling and Reference Pulse

A custom compatible replacement for 14-14361-1024 can be supplied by EncoderWorks with the main check placed on 10–30 V push-pull receiver matching, 1024 PPR controller scaling, and ATEX reference-pulse reliability. This model should not be treated as interchangeable with 1000, 512, or 2048 PPR versions. The pulse value is common, but the controller must still match the exact scaling, quadrature mode, and zero-channel logic.

The 14-14361-1024 is an ATEX incremental rotary encoder configuration with photoelectric sampling, 1024 PPR, 10–30 V push-pull output, A/B/0 plus inverted signal channels, IP66 protection, Ø12 mm keyed shaft, clamping flange, and 9-core 2 m cable connection. At 1024 PPR, both controller scaling and 100 kHz signal margin should be checked.

The first failure boundary is exact pulse interpretation. If the PLC, drive, or counter expects 1000, 500, 512, or another pulse count, A/B signals can remain stable while speed, distance, or angular feedback becomes wrong. The 0 reference pulse must also match the original indexing or homing logic.

This replacement fails when A/B/0 signals are stable, but the controller calculates the wrong motion value because 1024 PPR scaling, push-pull input threshold, quadrature mode, or reference-pulse handling does not match the previous encoder. That is a configuration and signal-chain failure, not a sensing failure.

The second boundary is push-pull channel mapping. A, B, 0 and inverted A, B, 0 must be wired by signal function. A wrong inverted channel can reduce noise rejection, disturb direction validation, or make homing unreliable.

Mechanically, the Ø12 mm keyed shaft and clamping flange must be checked with the coupling, pulley, or measuring wheel. ATEX suitability, PE shielding, cable route, and axial/radial shaft-load limits remain part of the replacement decision.

The replacement decision should first confirm ATEX marking, Ø12 mm keyed shaft fit, clamping-flange centering, 1024 PPR scaling, 10–30 V push-pull receiver compatibility, A/B/0 plus inverted channel mapping, 100 kHz output-frequency margin, shield grounding, cable route, operating speed, and shaft load. EncoderWorks treats 14-14361-1024 as an industrial encoder custom compatible solution where push-pull signal matching and reference-pulse reliability decide field performance.

Typical production lead time: 15 working days.

Key Data