For ESM58N-F1APNR0BN-1416, EncoderWorks can provide a custom compatible replacement focused on PROFINET device setup, 16/14-bit position mapping, and Ø10 mm recessed hollow-shaft fit. This model should not be treated like the 13/12-bit version. The shaft interface may match, but the PLC must still accept the higher resolution structure, device name, GSDML module configuration, preset value, and counting direction.
The ESM58N-F1APNR0BN-1416 is a PROFINET multiturn absolute encoder configuration with binary code, 16-bit singleturn resolution, 14-bit multiturn range, 10–30 VDC supply, aluminum housing execution, Ø10 mm x 30 mm recessed hollow shaft, radial M12 Ethernet and power connection, and integrated 2-port switch.
The first failure boundary is PROFINET parameter agreement. Device name, IP assignment, GSDML selection, update time, RT/IRT mode, and module data length must match the controller project. Link and Active LEDs can be normal while the PLC still reports configuration mismatch or no valid position.
This replacement fails when Ethernet link is present, but the PLC reads no valid position because PROFINET device name, module configuration, 16/14-bit resolution mapping, preset value, or counting direction does not match the previous encoder. That is a network-parameter failure, not a sensing failure.
The second boundary is Ø10 mm recessed hollow-shaft installation. This is not a solid-shaft encoder and not a simple through-hollow shaft. The machine shaft must enter within the correct insertion range, and the torque rest must prevent housing rotation without creating radial or angular offset.
The replacement decision should first confirm PROFINET compatibility, GSDML configuration, device name, IP assignment, M12 D-coded port mapping, M12 A-coded supply, 16-bit singleturn and 14-bit multiturn mapping, binary code, preset value, counting direction, Ø10 mm recessed hollow-shaft fit, 15–30 mm insertion depth, torque rest contact, shield grounding, and offset limits. EncoderWorks treats ESM58N-F1APNR0BN-1416 as an industrial encoder custom compatible solution where PROFINET setup and Ø10 recessed-shaft mechanics decide field reliability.
Typical production lead time: 15 working days.
Key Data
| Item | Data |
|---|---|
| Model | ESM58N-F1APNR0BN-1416 |
| Encoder type | Multiturn absolute encoder |
| Interface | PROFINET IO / IRT |
| Resolution | 16-bit singleturn + 14-bit multiturn |
| Code | Binary |
| Supply voltage | 10–30 VDC |
| Housing execution | Aluminum, powder coated |
| Shaft type | Recessed hollow shaft |
| Shaft size | Ø10 mm x 30 mm |
| Connection | M12 Ethernet ports + M12 power connector |
| Network feature | Integrated 2-port switch |
| Main engineering anchor | PROFINET setup and Ø10 recessed shaft |
| Main failure boundary | Wrong device name, configuration mismatch, scaling error, shaft insertion fault |
