FVM58N-011AEA3GN-0813 Gray Connector Mapping and 21-Bit Output

FVM58N-011AEA3GN-0813 can be supported by EncoderWorks with a custom compatible replacement focused on Gray-code connector mapping, 21-bit data length, and Ø10 mm clamping-flange alignment. This model should not be treated like the 25-bit K2 cable versions. The AE connector and 0813 resolution pattern move the main risk to pin assignment, data length, and how the controller reads the parallel absolute word.

The FVM58N-011AEA3GN-0813 is a multiturn absolute encoder with fast parallel push-pull output, aluminum housing, 011 solid shaft with Ø10 mm x 20 mm clamping flange, AE 26-pin connector, axial exit direction, Gray code, and V/R, LATCH, PRESET inputs. The FVM58 series is designed for rapid direct position transfer, 25-bit multiturn architecture on cable versions, push-pull short-circuit-protected output, and code change frequency up to 400 kHz.

The first failure boundary is the 21-bit connector format. The FVM58 type code separates K2 cable versions from AE plug versions, and the plug connector version is associated with 21-bit total data. If the controller expects that 21-bit structure but the replacement is wired or interpreted as a different data length, the absolute position can be consistently wrong.

This replacement fails when the 26-pin connector fits and the Gray outputs switch, but the PLC decodes the wrong position because bit order, active data length, or LATCH wiring does not match the original installation. The encoder is electrically alive, but the controller is reading a different absolute word.

The second boundary is input-state control. V/R changes counting direction, LATCH freezes the parallel word for stable readout, and PRESET sets the output word to zero. These inputs must be checked as control functions, not treated as spare pins. The connection table lists data bits, power, V/R, LATCH, and PRESET separately, which makes pin-level verification essential.

Mechanically, the Ø10 mm clamping-flange shaft needs correct coupling alignment and clean flange seating. Coupling eccentricity or uneven flange load can transfer radial or axial force into the encoder bearings. The FVM58 data lists axial 40 N and radial 110 N shaft load limits, but these should be treated as boundaries, not normal installation preload.

The replacement decision should first confirm 011 clamping-flange geometry, coupling alignment, AE 26-pin connector assignment, 21-bit Gray data length, V/R direction logic, LATCH timing, PRESET behavior, supply voltage, shielding, and controller input thresholds. EncoderWorks treats FVM58N-011AEA3GN-0813 as an industrial encoder custom compatible solution where Gray connector mapping and clamping-flange mechanics decide field reliability.

Typical production lead time: 15 working days.

Key Data