We developed a custom solution for the GA241.B12C102 encoder, intended for applications where stable 13-bit binary parallel absolute position output must be maintained under industrial noise, direct PLC input structures, and fixed-cable installation conditions. This configuration is based on the GA241 singleturn parallel absolute encoder platform, using a synchro flange, Ø6 mm solid shaft, 10–30 VDC supply, and binary push-pull output through a 21-core cable. It is not a serial interface device and it is not tolerant of loose control logic. It is a parallel data system where STORE, ENABLE, UP/DOWN, Zero setting, and cable routing quality determine whether the position word remains usable. Typical production lead time: 15 working days.
Custom Solution Photos
Stable operation depends on shaft alignment, synchro flange rigidity, cable integrity, and clean parallel signal handling.
System Limits
- No STORE signal during readout → position data can change during sampling
- ENABLE not held active → outputs switch to high-impedance and appear lost
- Weak shielding or poor cable routing → bit errors and unstable absolute values
The GA241 platform is a 13-bit optical singleturn parallel encoder with 8192 steps per turn, push-pull short-circuit-proof outputs, and permanent code continuity check. In the cable version, the signal chain becomes more dependent on routing discipline, shielding quality, and strain relief. The system may show false absolute values even when the encoder itself is mechanically normal, simply because the 13 parallel data lines and control signals are handled incorrectly through the cable.
This model uses binary code, which is simple for direct PLC mapping but more sensitive to asynchronous bit transitions than Gray code. For that reason, the STORE input is not optional in real systems. The datasheet explicitly notes that this line must be applied for reliable data readout in binary code.
Installation and Wiring Constraints
- Use rigid synchro flange mounting and maintain proper shaft alignment
- Use the STORE input to latch data before reading
- Keep ENABLE at active low during output operation
- Define UP/DOWN correctly to match the real shaft direction
- Return Zero setting to GND after setting for best interference immunity
- Protect the 21-core cable from crushing, repeated flexing, and uncontrolled EMC exposure
- Shield all D0 to D12 data lines and control lines in noisy environments
Failure boundary:
- Missing STORE logic → unstable binary readout
- ENABLE high → no usable output
- Wrong UP/DOWN logic → reversed position behavior
- Poor cable routing or shielding → corrupted parallel word
- Excess shaft load or misalignment → reduced mechanical reliability
Replacement and Interface Mapping
- Suitable for systems requiring 13-bit binary parallel absolute position feedback with cable output
- Applicable where synchro flange mounting, Ø6 mm shaft, and direct cable integration are required
- Not suitable where serial interfaces are expected or where parallel timing and cable routing cannot be controlled
- Best used in control systems that can manage latch, enable, direction, and cable shielding correctly
Key Data
- Model: GA241.B12C102
- Type: Singleturn absolute encoder, parallel
- Sensing method: Optical
- Resolution: 13 bit / 8192 steps
- Code: Binary
- Output circuit: Push-pull, short-circuit proof
- Supply voltage: 10–30 VDC
- Initializing time: typ. 20 ms
- Accuracy: ±0.025°
- Shaft: Ø6 mm solid shaft
- Flange: Synchro flange
- Connection: 21-core cable
- Max speed: ≤10000 rpm mechanical / ≤6000 rpm electrical
- Shaft load: ≤20 N axial / ≤40 N radial
- Protection: IP54 without shaft seal / IP65 with shaft seal
- Operating temperature: -25 to +85 °C
- Housing: Ø58 mm aluminium
GA241.B126102 Encoder Solution
GA241.B125102 Absolute Encoder
GA241.B106102 Industrial Encoder
GA241.B105102 Encoder Solution
