OCM-CAA1B-1213-F10W-HFZ CANopen and ATEX Clamp Shaft

OCM-CAA1B-1213-F10W-HFZ is not replaced safely by matching only the CANopen label or the ø10 mm shaft; EncoderWorks treats it as a custom compatible absolute encoder solution where DS-406 profile behavior, 13/12-bit scaling, CANopen address, baud rate, termination, ATEX clamp-flange fit, and radial connection-cap wiring must be confirmed together. This replacement fails when the controller detects a CANopen node but the resolution, preset value, CAN identifier, transmission mode, limit functions, or shaft reference does not reproduce the original encoder behavior.

The OCM-CAA1B-1213-F10W-HFZ is a CANopen multiturn absolute encoder configuration with optical sensing, 13-bit singleturn resolution, 12-bit multiturn range, binary code, mechanical geared multiturn technology without battery, 10–30 VDC supply, galvanically isolated CAN transceiver output, stainless-steel housing, stainless-steel connection cap, ø10 mm x 20 mm solid shaft with single flat, clamp ø78 mm ATEX flange, radial connection orientation, and IP66/IP67 protection. The controller should continue reading 8192 steps per revolution across 4096 turns.

The first failure boundary is CANopen parameter matching. The encoder follows the DS-406 profile and supports programming of resolution, preset, limit switches, CAM functions, baud rate, CAN identifier, bootloader, and transmission modes such as polled, cyclic, and sync. If the replacement is installed with a different address, baud rate, object dictionary setup, preset value, or transmission mode, communication may be present while the actual position value remains wrong.

This replacement fails when CANopen communication is present, but the controller reads the wrong multiturn position because node ID, baud rate, termination, DS-406 scaling, preset, CAN identifier, or 13/12-bit parameterization does not match the original encoder.

The second boundary is hazardous-area mechanics. The ø10 mm solid shaft, clamp flange, radial connection cap, stainless housing, shaft load, shield grounding, blind-plug arrangement, and IP66/IP67 sealing must be checked together. ATEX Zone 1 & 21 use makes cable entry and enclosure handling part of the replacement decision, not an accessory detail.

The replacement decision should first confirm CANopen DS-406 compatibility, node address, baud rate, terminal resistor status, 13-bit singleturn and 12-bit multiturn scaling, binary code, preset and limit-switch functions, 10–30 VDC supply, radial connection-cap wiring, ø10 mm solid-shaft fit, clamp ø78 mm ATEX flange mounting, stainless-steel housing requirement, IP66/IP67 sealing, shaft-load limits, and hazardous-area installation rules. EncoderWorks treats OCM-CAA1B-1213-F10W-HFZ as an industrial encoder custom compatible solution where CANopen parameter accuracy and ATEX mechanical integration decide field reliability.

Typical production lead time: 15 working days.

Key Data