OCD-PPA1G-0010-CA30-CRW Parallel Single-Turn Encoder, 10 mm Shaft

We developed a custom solution for model OCD-PPA1G-0010-CA30-CRW. Selected when higher-resolution single-turn absolute feedback is required via parallel push-pull output, using a 58 mm clamping flange with 10 mm solid shaft, without introducing multi-turn complexity or fieldbus communication. Typical production lead time: 15 working days.

Key Specifications

• Interface: parallel push-pull
• Resolution: 10-bit single-turn (Gray code)
• Supply: 10–30 VDC
• Protection: IP65
• Structure: 58 mm clamping flange, 10 mm solid shaft, 20 mm shaft length
• Cable: 1 m radial PVC
• Speed: up to 12000 rpm

Decision Snapshot

• Best for: high-speed single-turn parallel positioning systems
• Key fit: 10 mm solid shaft, 58 mm clamping flange
• Avoid if: multi-turn feedback or bus communication is required

Custom Solution Photos

Encoder structure reference: 58 mm clamping flange, 10 mm solid shaft, radial cable outlet.

Signal & Output Logic

• Bit 1–10 parallel output
• Includes Latch and DIR control
• Direction configurable via wiring

Primary integration reason: direct controller-side reading of higher-resolution single-turn position without bus latency.
Primary limitation: no multi-turn retention; position resets after one revolution cycle.

Wiring & Installation

• Connection: 1 m radial PVC cable
• Minimum bend radius: ~150 mm

Primary commissioning risk: incorrect bit sequence or Latch/DIR logic at controller input.
Primary installation value: high allowable speed (up to 12000 rpm), making it suitable where shaft speed is a constraint.
Primary mechanical constraint: coupling alignment must be controlled, as bearing load increases significantly with radial or axial misalignment.

Integration & Compatibility

• Designed for parallel absolute encoder systems
• Matches 58 mm clamping flange installations with 10 mm shaft
• Suitable for direct high-speed position feedback without conversion
• Not suitable for multi-turn systems or fieldbus-based architectures

Lead Time

Typical production lead time: 15 working days. Custom adaptation available for shaft configuration, cable routing, and signal assignment.

Key Technical Data