OCD-PPA1B-00AA-C100-CRW Custom Parallel Push-Pull Encoder Solution

We developed a custom solution for model OCD-PPA1B-00AA-C100-CRW. This version is a single-turn absolute encoder with parallel push-pull output, 58 mm clamping flange, and 10 mm solid shaft. The source page shows 9-bit resolution, 10–30 VDC supply, 1 m radial cable, and enclosure protection rated IP65 on shaft side / IP66-IP67 on housing side. Typical production lead time: 15 working days.

Technical Key Parameters

This model is for systems that still require direct discrete bit output instead of fieldbus communication. The output driver is push-pull, and the listed signal allocation includes Bit 1 to Bit 9, plus Latch, DIR, Power Supply, and GND. For retrofit work, that is the core decision anchor: the project must confirm controller input type and bit-width first, because once the machine side is parallel-input based, replacing it with a bus encoder is usually not the quickest path.

Mechanically, this version uses a 10 mm solid shaft with single flat, 20 mm shaft length, clamping flange, and maximum mechanical speed up to 12000 rpm. It also lists axial/radial shaft load values and moderate friction torque, making it a useful choice where the machine already expects a classic shaft-mounted absolute encoder with cable output. The 9-bit format corresponds to 0–359 on the source page, which makes this version particularly direct for one-degree class position tasks.

Custom Solution Photos

Wiring and Installation Notes

This version uses a 1 m radial PVC cable. The signal map assigns individual colors for Bit 1 through Bit 9, plus Latch, DIR, Power Supply, and GND. In installation, the important point is not only correct bit order but also consistent common reference and input timing on the receiving controller. On the mechanical side, keep coupling alignment under control and do not overload the 10 mm shaft, especially on high-speed applications where misalignment quickly shortens service life.

Custom Compatible Encoder Solution

• Custom single-turn absolute solution with parallel push-pull 9-bit output
• Adaptation available for 58 mm clamping flange and 10 mm solid shaft
• Wiring sequence, direction logic, and latch behavior can be matched to the control side
• Practical replacement choice for machines still using direct parallel position input

Lead Time and Custom Development

Typical production lead time: 15 working days.
If the machine side has fixed bit mapping, cable exit preference, or shaft-coupling constraints, we can build the custom version around those confirmed details.

Key Technical Data