This replacement model for the CRF66-4096G4096A01 is developed as a precise 1:1 parallel absolute encoder substitute, fully matching the original 4096×4096 multi-turn resolution and parallel output configuration. All mechanical and electrical characteristics—including flange interface, shaft connection, housing dimensions, and connector layout—are accurately reproduced to allow direct installation without control system modification. Through an optimized customization process, this solution helps reduce replacement cost while maintaining a stable production lead time of approximately 10–15 working days.
In operation, the encoder delivers reliable and repeatable multi-turn absolute feedback under continuous industrial conditions. Its robust mechanical structure and stable signal output support long-term accuracy and dependable performance. Low-volume and non-standard customization can be supported, making this replacement model suitable for CNC machinery, automated production lines, wind energy systems, and heavy-duty material-handling applications where consistent parallel feedback is essential.
Electrical data
| Parameter | Value |
| Electrical data (Valid for all versions unless otherwise stated) | |
| Sensor system | GaAlAs diode, photo-transistor array, precision comparator |
| Parallel output circuits | A = Open collector, C = Darlington, D = Push pull |
| Serial outputs | Differential output to RS422 |
| SS/ ASA | Differential (opto-coupler) for data driver RS 422 |
| Parity bit | Check bit (not to RS - 22 Bit) |
| Error bit output | Data Bit (parallel and SS/ 32 Bit only) |
| Enable circuit for bus operation | Active or inactive |
| Multifunctional inputs (MFP) | Signal input 6 |
| Memory circuit (latch) | Through MFP |
| Code sense | CW or CCW |
| Supply voltage range | 11 to 26 VDC |
| Supply current | 80 mA typ. / 120 mA max. |
| Data rate | 1 to 3 kHz, depending on programming (parallel interface only) |
| Measurement position deviation | ≤ ± 238' (for 4096 pos. / 360°) |
| Disc coding | Gray code |
| Setting cycles EEPROM | ≤ 10^6 |
| Mechanical data | |
| Operating speed | 3000 rpm max. (continuous), 4000 rpm max. (short period) |
| Operating torque | 5 Ncm min. (at 1000 rpm) |
| Wind-up torque | ≤ 10 Ncm (4 Ncm - CRF 66) |
| Angular acceleration | 10^6 rad/s^2 max. |
| Inertial mass of rotor | 50 gcm^2 |
| Permissible axial and radial shift load | 250 N max. |
| Bearing life expectancy | 10^6 turns |
