This custom replacement for the CRF105-4096G4096A08 is engineered to replicate the original 4096×4096 multi-turn absolute resolution and parallel output interface. Mechanical and electrical details—including shaft configuration, flange geometry, housing dimensions, and signal layout—are precisely matched to enable direct installation without system modification. By using a flexible customization approach, this solution helps reduce replacement cost while ensuring stable long-term availability. Typical production lead time is 10–15 working days, supporting fast response to sourcing challenges.
In operation, the encoder delivers smooth and reliable multi-turn position feedback under continuous industrial use. Signal stability and mechanical robustness support consistent accuracy over extended service cycles. Low-volume and non-standard customization can be supported, making this custom replacement suitable for CNC equipment, conveyor systems, industrial drives, and lifting mechanisms that require dependable parallel absolute feedback and predictable delivery.
Electrical data
| Parameter | Value |
| Electrical data (Valid for all versions unless otherwise stated) | |
| Sensor system | GaAlAs diode, photo-transistor array, precision comparator |
| Parallel output circuits | A = Open collector, C = Darlington, D = Push pull |
| Serial outputs | Differential output to RS422 |
| SS/ ASA | Differential (opto-coupler) for data driver RS 422 |
| Parity bit | Check bit (not to RS - 22 Bit) |
| Error bit output | Data Bit (parallel and SS/ 32 Bit only) |
| Enable circuit for bus operation | Active or inactive |
| Multifunctional inputs (MFP) | Signal input 6 |
| Memory circuit (latch) | Through MFP |
| Code sense | CW or CCW |
| Supply voltage range | 11 to 26 VDC |
| Supply current | 80 mA typ. / 120 mA max. |
| Data rate | 1 to 3 kHz, depending on programming (parallel interface only) |
| Measurement position deviation | ≤ ± 238' (for 4096 pos. / 360°) |
| Disc coding | Gray code |
| Setting cycles EEPROM | ≤ 10^6 |
| Mechanical data | |
| Operating speed | 3000 rpm max. (continuous), 4000 rpm max. (short period) |
| Operating torque | 5 Ncm min. (at 1000 rpm) |
| Wind-up torque | ≤ 10 Ncm (4 Ncm - CRF 66) |
| Angular acceleration | 10^6 rad/s^2 max. |
| Inertial mass of rotor | 50 gcm^2 |
| Permissible axial and radial shift load | 250 N max. |
| Bearing life expectancy | 10^6 turns |
