This Custom Replacement for the CBE58-4096RCE01 parallel absolute encoder is engineered as a specification-focused alternative for systems that continue to rely on this exact configuration. Instead of generic adaptation, the design is built around reverse-verified mechanical geometry and signal behavior, ensuring alignment with the original encoder’s installation logic. The replacement is intended to support maintenance of long-running equipment where redesign is impractical and compatibility accuracy is essential.
From an application standpoint, this model is well suited for parallel absolute feedback tasks in established automation lines, positioning units, and control systems that depend on stable multi-bit output. Particular attention is given to operational consistency under continuous load, as well as tolerance to vibration and environmental variation commonly found in legacy installations. With a standardized production arrangement, the delivery cycle is controlled at approximately 15 working days, allowing maintenance teams to plan replacements more predictably and reduce the operational risks associated with obsolete components.
Technical data
| Sensor system | GaAlAs diodes, photo-transistor array |
| Resolution | 4096 positions / 360°; 8192 positions / 360° (optional); 3600 positions / 360° (optional) |
| Data Control - Bit (DCB) | Optional at ≤ 4096 positions |
| Disc coding | Gray or Gray - Excess |
| Measuring position deviation | ≤ ± 2'38'' at 4096 positions / 360°; ≤ ± 1'59'' at 8192 positions / 360° |
| Parallel output circuits | A = Open Collector Darlington; C = Open Emitter Darlington; D = Push - pull |
| Output frequency | 10 kHz max. |
| Latch | via signal input E1 |
| Enable circuit | on / off, via signal input E1 |
| Serial output circuit | E = SSI Differential to RS 422 / 485 |
| Output Code | Gray or Gray - Excess for non - binary outputs |
| Code sense | CW or CCW, via signal input E2 |
| Supply voltage range | +11 VDC to +30 VDC |
| Supply current (parallel) | 50 mA typ. / 70 mA max. |
| Supply current (serial SS) | 60 mA typ. / 80 mA max. |
| Operating speed | 3000 rpm max. (continuous); 4000 rpm max. (short period) |
| Angular acceleration | 10⁵ rad/s² max. |
| Inertial mass of rotor | 45 gcm² |
| Operating torque | ≤ 5 Nm (8 Nm - CBE 66) (at 1000 rpm) |
| Wind - up torque | ≤ 1 Nm (4 Nm - CBE 66) |
| Permissible axial and radial shaft load | 250 N max. |
| Bearing life expectancy | 10⁹ turns |
| Mass | 0.5 kg |
