8.A124.68C2.C212 PROFINET Encoder with Ø24 mm AX Adapter

For 8.A124.68C2.C212, EncoderWorks can provide a custom compatible replacement solution for large-shaft PROFINET absolute encoder systems where the key checks are ø24 mm H7 bore fit, encoder-side locking-ring clamping, 70 mm torque-arm preload, PROFINET device configuration, and three-M12 connector wiring. This model should not be treated like the ø28 mm version, because the encoder interface remains the same while the AX adapter bore changes to ø24 mm, making shaft fit and clamp alignment the first replacement boundary. Typical production lead time: 15 working days.

This configuration combines a Kübler AX hollow-shaft adapter with a Sendix 5868 absolute multiturn encoder. The AX section provides the ø24 mm hollow-shaft bore, locking ring on the encoder side, and 70 mm torque arm, while the encoder body provides PROFINET IO absolute position feedback through three radial M12 connectors. Replacement work should focus on shaft fit, clamping torque, torque-arm alignment, device name, IP assignment, GSDML file matching, scaling parameters, preset behavior, network diagnostics, and shield grounding.

System Limits

The first system limit is PROFINET commissioning. The controller must preserve the original device name, IP setting, GSDML version, encoder protocol behavior, scaling, preset value, counting direction, and diagnostic response. If the encoder appears online but the profile or scaling differs, the PLC may receive stable position data while converting it into the wrong mechanical value.

The second limit is AX mechanical installation. The ø24 mm shaft must match the H7 adapter bore without forcing the clamp, and the locking ring must clamp from the encoder side. Shaft runout, excessive clamp force, or torque-arm preload can create bearing load, housing movement, or repeatability drift.

The third limit is the AX operating envelope. The adapter is rated IP64 and has temperature-dependent speed limits. High shaft speed, high ambient temperature, or a loaded torque arm can become the practical failure boundary before the PROFINET interface itself becomes unstable.

Wiring & Installation

Before replacement, record the PROFINET device name, IP address, GSDML file, scaling parameters, preset value, counting direction, alarm handling, and diagnostic behavior from the controller project. Also record the three radial M12 connector assignments for PROFINET ports, supply voltage, ground, and shield connection.

During installation, confirm the ø24 mm H7 shaft fit, keep the locking ring on the encoder side, and align the 70 mm torque arm without preload. Route PROFINET and power cables away from inverter output wiring, maintain shield continuity through the M12 connectors, and avoid ground loops between the encoder housing, machine frame, and cabinet earth. After startup, verify device recognition, actual position value, direction, preset response, diagnostics, torque-arm movement, and repeatability over several machine cycles.

Custom Compatible Solution

EncoderWorks can configure the replacement around the installed shaft and PROFINET control system:

• Match the AX ø24 mm hollow-shaft adapter, encoder-side locking ring, 70 mm torque arm, and mounting envelope
• Preserve Sendix 5868 PROFINET IO encoder protocol behavior, GSDML setup, scaling, preset, and direction response
• Adapt the three radial M12 connector layout, 10–30 VDC supply range, Ethernet wiring, and shield grounding
• Review clamp torque, shaft fit, torque-arm preload, IP64 installation limits, network diagnostics, and temperature-speed operating margin

Key Data