1075601-01 RSA 507 SSI Gray Shaft Compatibility

EncoderWorks provides a custom compatible replacement solution for 1075601-01 RSA 507 focused on maintaining SSI Gray communication behavior, Ø10 mm shaft adaptation, and singleturn position data consistency. The replacement challenge is not only matching the 13-bit absolute feedback output, but also preserving SSI clock/data timing, synchro flange mounting conditions, and controller-side position interpretation. SSI communication may remain active while incorrect timing, signal mapping, or mechanical alignment still affects position accuracy.

System Limits

SSI replacement reliability depends on maintaining consistent serial communication between the encoder and the controller. The 1075601-01 RSA 507 uses SSI Gray output with 13-bit singleturn resolution. Clock timing, inverted clock/data signals, hold function, code sequence direction, and Gray code interpretation must be matched because differences in serial data processing can result in incorrect position values or additional commissioning adjustments.

The mechanical integration boundary includes shaft fit, flange mounting, and installation stability. This model uses a Ø10 mm shaft with partial flat and a synchro flange (63-type) mounting structure, together with a 1.5 m radial cable connection. Shaft orientation, partial flat alignment, flange positioning, cable routing, shielding, and grounding continuity should be maintained because mechanical mismatch or electrical interference can affect long-term position feedback reliability.

Wiring & Installation

SSI integration requires verification of clock, inverted clock, data, inverted data, hold, code sequence, power supply, and chassis shield connections. The configuration uses dedicated SSI signal wiring through the radial cable connection. Incorrect signal mapping, missing complementary signals, poor shielding, or improper grounding may result in unstable serial communication or inaccurate position evaluation.

During replacement installation, the Ø10 mm shaft with partial flat and synchro flange interface should be checked against the existing machine structure. The radial cable outlet, mounting stability, vibration conditions, and environmental protection requirements should be considered together to maintain reliable SSI feedback performance.

Custom Compatible Solution

• Match SSI Gray communication behavior and controller-side serial data interpretation.
• Preserve 13-bit singleturn position structure and code sequence configuration.
• Adapt Ø10 mm shaft with partial flat and synchro flange (63-type) mounting requirements.
• Validate SSI timing, signal mapping, shielding, and grounding conditions.

Typical production lead time: 15 working days.

Key Data